Our preferred (and your least expensive) option for Attachment is any of thefollowing Crimp methods:

Thank you for using our Custom Cable Designer!

Be sure to select all of your Connector 1, Connector 2 and Coax parameters to narrow your results.

Clocking refers to the angle difference between two right-angle connectors. Clockingis measured in degrees, from the front connector lying flat and right-facing, counter-clockwiseto the rear connector.

Heat shrink is applied to both ends of the assembly for crimp or solder cable attachments. Note:Heatshrinkis not added to semi-rigid assemblies or clamp/compression style connectors.

Heat shrink is applied to both ends of the assembly for crimp or solder cable attachments. Note:Heatshrinkis not added to semi-rigid assemblies or clamp/compression style connectors.

You're Almost Done!

Please ensure all parameter boxes for Connector 1, Connector 2, and your Cable are selected.

Almost Done!

You have built a brand new configuration. Please click below to continue.