Page 1764 - 1.0/2.3 to SHV RF Connector Datasheets

HN Male Right Angle Connector Clamp/Solder Attachment
for RG213, RG8, RG393, RG225, RG214, RG393, RG9

RF Connectors Technical Data Sheet PE4230

Assembly Instruction

1
2
4

6

3

5

1. SLIDE CLAMP NUT 1 , THIN-WASHER 2 & GASKET 3 OVER CABLE. STRIP
CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF
BRAID TO PERMIT ASSEMBLY OF CLAMP.
.30
7.6

2. SLIDE BRAID CLAMP 4 OVER BRAID & SEAT AGAINST CABLE. FORM BRAID
OVER CLAMP NUT. TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER
CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR.
.05
1.3

.13
3.3
3. SOLDER CONTACT 5 TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER.
DO NOT OVER HEAT DIELECTRIC.INSERT CABLE ASSEMBLY INTO BODY 6 &
TIGHTEN.
SOLDER

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: HN Male Right Angle Connector Clamp/Solder Attachment for RG213, RG8, RG393, RG225,
-
RG214, RG393, RG9 PE4230 Pasternack does not make
any representation or warranty regarding the suitability of the part described herein for any particular purpose, and Pasternack does not assume any liability arising out of the use of any part or documentation.

PE4230 REV 1.5 3