Page 2399 - 1.0/2.3 to SHV RF Connector Datasheets

N Male Connector Clamp/Solder (Captive Contact)
Attachment for RG213, RG214, RG8, RG9, RG11,
RG225, RG393, RG144, RG216, RG215

RF Connectors
Technical Data Sheet PE4132

Assembly Instruction
1
2
3
4
5
6 6
8

7

1. SLIDE CLAMP NUT 1 , THIN-WASHER 2 & GASKET 3 OVER CABLE. STRIP CABLE AS SHOWN. DO
NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT ASSEMBLY OF CLAMP.
.40
10.2

2. SLIDE BRAID CLAMP 4 OVER BRAID & SEAT AGAINST CABLE. FORM BRAID OVER CLAMP NUT.
TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER CONDUCTOR TO DIMENSION SHOWN.
DO NOT NICK CENTER CONDUCTOR.
.080
2.03

.200
5.08
3. SLIDE THICK-WASHER 5 AND HALF- INSULATOR 6 AGAINST THE BRAID CLAMP AND HOLD BRAID
IN PLACE. SOLDER CONTACT 7 TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER
HEAT DIELECTRIC.SLIDE A REST HALF- INSULATOR 6 TO LOCKED CONTACT. INSERT CABLE
ASSEMBLY INTO BODY 8 & TIGHTEN.
INSULATOR

SOLDER

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: N Male Connector Clamp/Solder (Captive Contact) Attachment for RG213, RG214, RG8, -
RG9, RG11, RG225, RG393, RG144, RG216, RG215 PE4132 Pasternack does not make
any representation or warranty regarding the suitability of the part described herein for any particular purpose, and Pasternack does not assume any liability arising out of the use of any part or documentation.

PE4132 REV 1.4 3