Page 359 - 1.0/2.3 to SHV RF Connector Datasheets

2.92mm Female Connector Clamp/Solder (Captive Contact)
Attachment End Launch PCB, Removable End Launch, 0.35 Width

RF Connectors
Technical Data Sheet PE45400

Assembly Instruction
End Launch Connectors - Installation Procedure

Step 1: Mount the end launch connector, PE45400, in the desired position on the board.
Step 2: Center the connector on the trace.

Step 3: Verify that the transition block is secured on the board.

Step 4: Tighten the 1-72 mounting screws to your boards suggested torque or until the connector
is secure.

(Steps 5 – 7 optional, depending on application)
Step 5: If soldering the launch pin to the trace,
flow solder the entire length of the contact area.
Step 6: To avoid performance mistakes, remove
excess solder.
Step 7: Clean any residue from around the solder
joint.
Example Assembly

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: 2.92mm Female Connector Clamp/Solder (Captive Contact) Attachment End Launch PCB, -
Removable End Launch, 0.35 Width PE45400 Pasternack does not make
any representation or warranty regarding the suitability of the part described herein for any particular purpose, and Pasternack does not assume any liability arising out of the use of any part or documentation.

PE45400 REV 1.4 3