Page 386 - 1.0/2.3 to SHV RF Connector Datasheets

2.92mm Female Connector Clamp/Solder
(Captive Contact) Attachment End Launch PCB,
Microstrip/Coplanar Launch, 0.005 inch

RF Connectors
Technical Data Sheet PE45470

Assembly Instruction

*

STEP 1 :
Insert end launch connector (including ground block & screws) in the edge position of
substrate.

Ground Block

STEP 2:
Tighten ground block against the substrate using two screws while ensuring flat pin
is centered on the trace.

M1.6 X P0.35
STEP 3:
Solder the flat pin to center trace on substrate while the connector is held in the
correct position.
(Note: solder should flow along the length of the exposed flat pin for good electrical
performance)

Soldering Point

STEP 4:
Remove any excess solder and clean all flux and other residues from the trace.

(Substrate shown for assembly instruction purposes only)

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: 2.92mm Female Connector Clamp/Solder (Captive Contact) Attachment End Launch PCB, -
Microstrip/Coplanar Launch, 0.005 inch PE45470 Pasternack does not make
any representation or warranty regarding the suitability of the part described herein for any particular purpose, and Pasternack does not assume any liability arising out of the use of any part or documentation.

PE45470 REV 1.1 3