Page 602 - 1.0/2.3 to SHV RF Connector Datasheets

7/16 DIN Male Connector Clamp/Solder Attachment
for RG393, RG214, RG225, RG215, RG8

RF Connectors
Technical Data Sheet PE4567

Assembly Instruction
1

3
5

2
4

ASSEMBLY PROCEDURES
1. SLIDE CLAMP NUT 1 , WASHER 2 & GASKET 3 OVER CABLE.
STRIP AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET.
TAPER END OF BRAID TO CABLE PERMIT ASSEMBLY OF BRAID
CLAMP 4 .
.79
20.0

2. SLIDE BRAID CLAMP 4 OVER BRAID & SEAT AGAINST CABLE.
FORM BRAID OVER CLAMP NUT 4 TRIM BRAID BACK TO
SHOULDER. CUT DIELECTRIC & CENTER CONDUCTOR TO
DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR
INSERT CABLE INTO BODY AND TIGHTEN.
.22
5.5

.62
15.8
3. SOLDER CENTER CONDUCTOR TO CENTER PIN FROM THE END.
REMOVE EXCESS SOLDER FOR A FLUSHED FINISH.

SOLDER

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: 7/16 DIN Male Connector Clamp/Solder Attachment for RG393, RG214, RG225, RG215, -
RG8 PE4567 Pasternack does not make
any representation or warranty regarding the suitability of the part described herein for any particular purpose, and Pasternack does not assume any liability arising out of the use of any part or documentation.

PE4567 REV 1.4 3