Page 2364 - 1.0/2.3 to SHV RF Connector Datasheets

N Male Connector Clamp/Solder Attachment for RG14, RG217

RF Connectors
Technical Data Sheet PE4221

Assembly Instruction

3

5
1
2

4

1. SLIDE CLAMP NUT 1 & GASKET 2 OVER CABLE. STRIP CABLE AS SHOWN. DO
NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT
ASSEMBLY OF CLAMP.
.40
10.2

2. SLIDE BRAID CLAMP 3 OVER BRAID & SEAT AGAINST CABLE. FORM BRAID OVER
CLAMP NUT. TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC TO DIMENSION
SHOWN. DO NOT NICK CENTER CONDUCTOR.
.18
4.6

.080
2.03
3. SOLDER CONTACT 4 TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO
NOT OVER HEAT DIELECTRIC.INSERT CABLE ASSEMBLY INTO BODY 5 & TIGHTEN.

SOLDER

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: N Male Connector Clamp/Solder Attachment for RG14, RG217 PE4221 -
Pasternack does not make
any representation or warranty regarding the suitability of the part described herein for any particular purpose, and Pasternack does not assume any liability arising out of the use of any part or documentation.

PE4221 REV 1.3 3