Page 282 - 1.0/2.3 to SHV RF Connector Datasheets

2.92mm Male Connector Clamp/Solder (Captive
Contact) Attachment End Launch PCB,
Removable End Launch, Standard Profile

RF Connectors
Technical Data Sheet PE45509

Assembly Instruction
Step 1: Mount the end launch connector in the desired position on the board.
Step 2: Center the connector on the trace.

Step 3: Verify that the transition block is secured on the board.
Step 4: Tighten the M1.6-0.35 mounting screws to the boards suggested torque or
until the connectors is secure.

(Steps 5-7 optional, depending on application)
Step 5: If soldering the launch pin to the trace, flow solder the entire length of the
contact area.
Step 6: To avoid performance mistakes, remove excess solder.
Step 7: Clean any residue from around the solder joint.

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: 2.92mm Male Connector Clamp/Solder (Captive Contact) Attachment End Launch PCB, Re- -
movable End Launch, Standard Profile PE45509 Pasternack does not make
any representation or warranty regarding the suitability of the part described herein for any particular purpose, and Pasternack does not assume any liability arising out of the use of any part or documentation.

PE45509 REV 1.0 3