Page 1101 - 1.0/2.3 to SHV RF Connector Datasheets

PE4379 CAD Drawing
BNC Male Connector Clamp/Solder Attachment for RG8X,
PE-C240, 0.240 inch, B7808A, LMR-240

9999
1

SIZE A
2
3

SCALE N/A

4 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME.

.941±.012 23.9±0.3 REF. 5 3. DIMENSIONS ARE IN INCHES [mm]. 081717

NOTES: CAD FILE
6

7
PE4379
.57 CAGE CODE 53919
14.5
DWG TITLE

OVER CABLE. STRIP 3 OVER BRAID & SEATAGAINST CABLE. FORM BRAID OVER .15 3.8 .10 2.5 TO 6 5 INSULATOR 7 R

ASSEMBLY PROCEDURES & GASKET 2 , THINNER WASHER CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF .30 7.6 3 2 1 4 CLAMP NUT. TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR. 4 3 2 1 AGAINST THE BRAID CLAMP. SOLDER CONTACT CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER HEAT DIELECTRIC. & TIGHTEN. 7 SOLDER 6 THE ENGINEER'S RF SOURCE Pasternack Enterprise

1. SLIDE CLAMP NUT 1 BRAID TO PERMIT ASSEMBLY OF CLAMP. 2. SLIDE BRAID CLAMP 5 3. SLIDE INSULATOR INSERT CABLE ASSEMBLY INTO BODY 5 4 3 2 1 STANDARD TOLERANCES .X ±0.2 .XX ±0.01 .XXX ±0.005 *STANDARD TOLERANCES APPLY ONLY TO DIMENSIONS IN INCHES

PE4379 REV 1.2 3